Repair Pictures




W140 Front Centre Console - Removal



W140 Climate Control LCD Backlight Replacement



W140 1992 Bose Beta System + CD Changer + Telephone



W140 1992 Bose Beta System - Aftermarket Stereo Upgrade Kit

MBCluster Stereo Upgrade Kit
Remember: Disconnect battery before beginning!
Removal Steps
Installation Steps



W140/R129 Aftermarket chrome ring set installation



W140 Closing Assist Pump - Removal



R129 1994 Bose System - Aftermarket Stereo Upgrade



R129 1991 Bose System - System Removal



W210 - Centre Console / Shifter - Removal

Console Removal
Remember: Disconnect battery before beginning!

Shifter Removal
Remember: place selector in "P" before disassembly!
This locks the transmission lever in "P" so it doesn't move out of place when you re-install.



W210 - Transmission Fluid Change, 722.6 - With Converter Plug

Transmission Parts & Assembly


Directions
  1. A large cardboard piece under the car is a good idea, as this job gets messy.
  2. Transmission can be drained either cold, warm or hot.
  3. Remove transmission shroud, examine any additional leaks. The electronic plug needs replacement, if its never been done.
  4. Find the torque converter drain plug by bumping the starter. Note: Engine turns clockwise only!
  5. Start with the transmission pan drain plug, should be about 3 liters of fluid. Detach the pan (6 bolts), there will still be about a half-inch of fluid left in the pan.
  6. Remove transmission filter.
  7. Drain torque converter, another 3 liters of fluid.
  8. Electrical plug detaches by rotating the cover by the tab.
  9. Clean everything!
  10. Re-assemble, plug, filter, pan with new gasket, hand tighten all bolts. Filter snaps into place, requires some force. New gaskets for both plugs.
  11. Torque Specs:
    • Transmission Pan torx bolts :TORX30 @ ~106 inch/lbs
    • Transmission Drain Plug: 5mm hex @ ~18 ft/lbs
    • Torque Converter drain plug: 5mm hex @ ~20 ft/lbs


  • Trans fluid is 236.12 rated, follow dealer recommendations.
  • Refill via transmission tube, it will seep out, so use cloths around neck.
  • Use 4L initially, moving through gears while stationary. Then add 2L, go for short drive to warm things up.
  • Use transmission level checking tool to verify correct level, should be around 7.3L. Check engine warm, idling in Park.
  • Check for leaks, then button everything up.
  • Temperature of fluid determines correct height as measured by tool.




W210 Customization - 1997 E300D Customized Modifications : Stereo, Shifter, Voltmeter




Email : Info@MBCluster.com

MBCluster | 8 Blacktoft Drive | Scarborough, Ontario | M1B 2M6 | (416)724-2149 | Email : Info@MBCluster.com